Call 844-335-0814 and our 24/7 service desk will connect you with an independent electrical contractor who handles warehouse lighting retrofits.
Signs your warehouse lighting needs a retrofit
- Fixtures take minutes to reach full brightness after switching on
- Dark spots between racks or in loading areas
- Frequent lamp and ballast replacements high above the floor
- Lights left on in empty areas all night
- Glare or flicker that makes picking and reading labels harder
What a lighting retrofit includes
A retrofit replaces old fixtures with LED high bay or linear fixtures, or converts existing fixtures where that makes sense. Many projects add occupancy sensors in aisles, daylight sensors near skylights and scheduling so lighting follows the working day. The contractor also checks circuits and mounting points, since retrofits are a good time to correct old wiring problems.
A lighting layout based on the racking and tasks in each area avoids simply copying the old fixture positions.
Running a retrofit without stopping operations
- Call 844-335-0814 and describe the building, ceiling height and current fixtures.
- We connect you with an independent contractor who does commercial lighting.
- The contractor surveys the space and proposes a fixture and control plan.
- Work is phased by zone, often at night or on weekends, using lifts.
- Controls are programmed and light levels are checked in each area.
Rebates for commercial lighting
Utilities often run rebate or incentive programs for commercial lighting upgrades, and terms change over time. Ask the contractor to check what is currently available from your utility before you finalize the fixture selection, since some programs require approval before installation.
Keep the fixture specifications and invoices, as most programs ask for them.
Light levels for different warehouse areas
Not every part of a warehouse needs the same light. Picking aisles and packing stations benefit from brighter, even light for reading labels, while bulk storage and lightly used areas can run at lower levels or rely on occupancy sensors.
A good retrofit plan treats each zone separately: aisles, open floor, loading docks, offices and exterior areas. Zoned controls then let you dim or switch off areas that are not in use without affecting active work areas.
Ask for a simple layout drawing showing fixture locations and control zones for your records.
Questions about Warehouse Lighting Retrofits
Can existing fixtures be converted instead of replaced?
Sometimes. Conversion kits work in some fixtures, but full replacement often gives better light and longer life.
Do occupancy sensors work in high ceilings?
Yes, with sensors designed for high bay mounting. The contractor will match sensor coverage to aisle widths and ceiling height.